Home - Products - Ball Bearings - Deep groove ball bearings - Inch size ball bearings - Open type - RMS Series

RMS Series

Deep groove ball bearings are non-separable and require little attention or maintenance in service, capable of operating at high speeds and are widely used radial bearings. The inner and outer ring of single row deep groove ball bearings have a deep groove raceway, the bearings are mainly used to carry radial loads and a part of axial loads in two directions. This kind of bearing can carry much heavy axial loads after the increase of radial clearance, thus, it can take the place of high speed angular contact ball bearings. Deep groove ball bearing have various types in structure, beside open type bearings, shield or seals at both side can also be provided
  Very good Good Normal Limited Not suitable/applicable  
Radial loadability Quiet running
Axial loadability in both directions Tapered bore
Length compensation within the bearings Seal at one or both sides
Length compensation with sliding fit High rigidity
Seperable bearings Low friction
Compensation misalignment Locating bearings
Increased precision Floating bearings
Suitability for high speeds    
Total  7 records
Boundary dimensions Basic load ratings Limiting speeds Mass(Kg)Bearing Number
d D B rs min Cr Co rpm (Approx.) PRB
in mm in mm in mm in
Total  7 records